The Sensirion SCC1 Connectivity Kit allows to connect Sensirion sensors with Sensirion SCC1-cables. The kit contains 3 cables which allow to connect products from the SLF3x-, LG16- and LS32-series directly to the M8-connector of the SCC1-series. Additional 2 cables have open leads making it easier connecting sensors from the SLF3x-series or the LG16-series to a microcontroller.

General

To obtain a sensor output different from the native I2C interface of Sensirion flow sensors, products from the SCC1 cable series can be used. These cables convert the I2C interface to UART (with a USB connector), RS485 (with SHDLC protocol), or an analog output (voltage or current). Since the SCC1 cables have an M8 connector while most Sensirion sensors use a Molex connector, an adapter cable is required.

The SCC1 Connectivity Kit includes a total of five cables: three cables designed to connect to SCC1 cables and two cables with open leads for customizable setups.

Compatibility Chart

The table below outlines the various connectors found on different Sensirion sensors and specifies the corresponding adapter from this kit required to connect them to an SCC1 cable.

Content

1x 5pin-Molex to M8 cable for connecting LG16-series sensors to SCC1-cable
1x 4pin-Molex to M8 cable for connecting LS32-series sensors to SCC1-cable
1x 6pin-Molex to M8 cable for connecting SLF3x-series sensors to SCC1-cable
1x 6pin-Molex to pigtail for connecting SLF3x-series sensors to custom setup
1x 5pin-Molex to pigtail for connecting LG16-series sensors to custom setup

Documentation

Application note for connecting Sensirion Sensors to Sensirion SCC1-cables